nuPro XI-2000 + Housing Set

Before connecting and operating the device, it is essential to read the user manual and especially its safety instructions thoroughly. For your own safety, be sure to observe all warning and safety instructions in this user manual and on the device. No work on the device, other than the described operations, should be performed by the user. Keep this document accessible at all times, and ensure it is passed on to future owners as well.

Intended Use

This device is intended exclusively for audio playback in dry indoor environments. Use it only as described in this user manual. Any other use (especially safety-critical or medical applications, outdoor installation unless specifically IP-certified) is considered improper and may result in property damage or personal injury. Nubert electronic GmbH assumes no liability for damages resulting from improper use.

General Information

Never operate the device unattended!

Risk of Electric Shock!

To avoid the risk of electric shock, the device must not be opened by the user. There are no user-serviceable parts inside the device. For service cases, please contact Nubert electronic GmbH directly!

Risk of Suffocation!

Never leave children unattended with the device or packaging materials! Children could become entangled in the packaging film and suffocate. Ensure that children cannot remove small parts from the devices! These parts could be swallowed and pose a choking hazard. If any parts are swallowed, contact a doctor immediately!

Risk of Injury or Damage!

When moving the device, handle it with the necessary caution to avoid injuries or damage!

Warning!

Since the device can only be completely disconnected from the power supply by unplugging it or switching off the circuit breaker, it must be positioned to ensure free access to the power plug or circuit breaker. If any of the following conditions occur, turn off the device immediately and disconnect it from the power supply. Contact Nubert electronic GmbH without delay!

• The device has been damaged or has fallen.
• The power cord or plug is damaged.
• Objects or liquids have entered the device.
• The device has been exposed to excessive moisture or rain.
• The device is not functioning properly or shows significant performance issues.
• The device emits a burning smell, smoke, or unusual noises.

Use only accessories recommended by Nubert!

Installation Instructions

This device must be installed in compliance with local, state, federal, and industrial regulations. It is the responsibility of the installer to ensure that the installation of the device and its mounting system complies with all applicable regulations, including local building codes. Consult the relevant local authority before installing this product.

Danger!

Unsafe mounting or suspension above head height or installation in unsuitable areas can result in severe injuries, fatalities, or property damage. It is the responsibility of the installer to evaluate the reliability of the mounting method for their application. Only attempt to install this device if you have the appropriate knowledge and hardware. If unsure about the installation, consult a qualified professional installer. Ensure the device is installed in accordance with local building codes!

• Ensure the mounting surface is stable and capable of securely supporting the device!
• Do not install the device on surfaces or areas where hazards like electrical wiring or pipes may be concealed behind.
• The device must be installed only on non-combustible surfaces.
• Avoid exposing the device to strong mechanical shocks!
• Do not expose the device to chemical substances such as mineral oil, lubricants, or cleaning agents, as these can degrade the plastic. Degraded plastic may become unstable, posing a fall hazard.

Warning!

Excessive heat buildup inside the device can shorten its lifespan or cause a fire.

• Never cover the device's cooling fins or ventilation openings! The device is not suitable for covering with thermal insulation material.
• Do not operate the device near heat sources such as radiators or stoves!
• Do not expose the device to direct sunlight.
• Never place burning candles or similar open flames in the vicinity of the device.

Risk of Electric Shock!

The device operates with internal mains voltage and may contain voltages exceeding 35 V AC or DC in certain areas. It is not specially protected against the ingress of liquids or objects. This poses a risk of fatal electric shock.

• Never touch the device with wet hands!
• Use the device only in a dry location!
• Do not operate it outdoors or in damp rooms!
• Protect the device from liquids of all kinds, including dripping and splashing water.
• Do not place containers with liquids (e.g., flower vases) on or near the device!
• If the device is brought from a cold to a warm environment, condensation may form inside. Wait at least 4 hours before turning it on to ensure it has reached room temperature and is dry!
• Avoid using the device during rapid temperature changes!
• Do not allow objects or foreign materials to enter the device or touch its electronics or electrical components.
• If the device comes into contact with liquids or if objects enter the interior, disconnect it from the power supply immediately and contact Nubert electronic GmbH.

Connection Instructions

General Connection Instructions

• Unplug the power cord before making any changes to the system wiring!
• Ensure all connections are correctly made and all plugs are firmly seated before connecting the device to the power supply!
• Use only the designated cables and connectors for connections! Otherwise, damage or malfunctions may occur.
• When disconnecting connections on the device, always pull on the plug, never the cable!
• Ensure all plugs are firmly seated and tightly screwed into their sockets!
• Use only cables and accessories recommended by Nubert!

Warning!

Power surges (e.g., caused by lightning strikes) can damage or destroy the device and its power supply unit.

• A surge protection element can provide some safety against excessive voltages in the power grid.
• Maximum safety can only be achieved by completely disconnecting your devices from the power grid and antenna systems. In case of thunderstorms or risk of lightning strikes, disconnect any antenna plugs from your HiFi system and interrupt the power supply, e.g., by switching off the circuit breaker!
• If the device will not be used for an extended period or will be unattended, the power supply should be disconnected. Unplug the power cord or switch off the circuit breaker!

Care and Cleaning Tips

Warning!

Improper handling of the device may cause damage.

• Always ensure the device is disconnected from the power supply before cleaning!
• Clean the device only with a dry, soft cotton cloth.
• Do not allow the device to come into contact with soap, mineral oil, alcohol, or other chemical cleaning agents or substances!
• Before resuming operation, ensure all connections are correctly made, no short circuits are present, and the device is completely dry.

Your device is intended for use in dry indoor environments. If you exceptionally operate the device outdoors, please ensure that it is protected from moisture (rain, water splashes, condensation).

Do not expose the TV set to dripping or splashing water (e.g. rain)!

Disconnect the mains plug before cleaning the device!

Do not hold the remote control directly in front of your eyes while pressing a button! Infrared light!

The television may only be operated with a mains voltage of 230–240 V~ 50 Hz.

For maintenance and servicing work, the mains plug or the appliance-side connector of the TV's power cord must, in accordance with the applicable standard, be regarded as and kept usable as the means of disconnecting the device from the mains supply.

Candles and other open flames must be kept away from this product at all times to prevent the spread of fire.

Opening the device and carrying out repairs must only be performed by qualified personnel. DANGER TO LIFE! Please contact your specialist dealer if repairs are required.

Bluetooth® devices operate using short-range radio signals. Under certain circumstances, these signals may interfere with the operation of other electronic devices and medical equipment.

Radio waves may affect the operation of pacemakers and other medical devices. Maintain a minimum distance of 20 cm!

Never spray cleaning fluid directly onto the screen surface! If cleaning fluid penetrates the lower frame of the screen, the components located there will be irreparably damaged.

The remote control is supplied with two LR03/AM4/AAA 1.5 V micro batteries. If a battery is swallowed, it can cause serious internal injuries within 2 hours, which may be fatal. If you suspect that batteries may have been swallowed or inserted into any part of the body, seek immediate medical attention. Keep new and used batteries out of the reach of children.

Metz Classic devices with a 3-pin IEC mains connector are internally designed as Class II devices with reinforced insulation. Therefore, the protective earth conductor is not connected within the device. One reason for this design is the prevention of ground loops.

• Do not insert rechargeable batteries into the remote control battery compartment. Only two LR03/AM4/AAA 1.5 V micro batteries may be used.
• A cold device may only be put into operation in a warm room once any condensation that may have formed on the screen surface has completely evaporated.
• Televisions require adequate cooling. The openings in the rear panel must not be covered by curtains or similar objects. The ventilation slots on the underside of the device must remain unobstructed, as the device draws cooling air through them.
• Ensure sufficient airflow for cooling if the device is installed in a cabinet.
• Do not place or mount the device directly next to or above a heater, as this may impair cooling performance.
• Do not place burning candles or containers filled with liquid on or above the TV set. Hot wax and liquids entering the interior of the device will damage the electrical components of the TV. In such cases, the electrical safety of the device can no longer be guaranteed.
• Thunderstorms pose a danger to electrical devices. A lightning strike on the power line or antenna can damage the device, even if it is switched off. During thunderstorms, disconnect the mains plug and antenna plug from the wall outlet and from the television.
• The TV set is intended exclusively for the reception and playback of audio and video signals.
• Do not display still images, logos, images with border bars, or similar content for extended periods. There is a risk that such static images may leave permanent marks on the screen.
• Soot and dust deposits may accumulate behind the TV panel glass even when no visible source of soot is present. Such deposits are also referred to as “fogging” or “magic dust.” This phenomenon may occur occasionally, particularly during the heating season, after renovation work, or in new buildings. Various factors are considered possible causes; further information can be found in reports available online. Cleaning or replacement of the panel in such cases is excluded from warranty claims, as this is not a defect of the device but the result of external influences.
• The screen surface must be cleaned using a dry, soft cleaning cloth (e.g. a microfiber cloth).
• If heavier soiling has nevertheless occurred, the screen surface may be cleaned using a slightly damp, soft cloth; see also Chapter 37.